Milling Speed and Feed Calculator – Calculate RPM and IPM for Milling Quickly and Accurately

How to calculate CNC milling speeds and feeds? Even if you know the milling speed and feed formulas, it still takes a lot of time to work out the results, especially when there are multiple cutting tools to select. Fast to determine spindle speed (RPM) and feed rate (IPM) for the milling operation using the Milling Speed and Feed Calculator, which saves time greatly and avoid mistakes during the calculation. You can also figure out the cut time in minutes based on the cut length and feed rate. Welcome to use Turning Speed and Feed Calculator and Drilling Speed and Feed Calculator at CNCLATHING.COM as well.

Note:

  1. The RPM calculated in the Mill Speeds and Feeds Calculator refers to the spindle speed in milling process, and IPM refers to feed rate.
  2. The exact RPM is not always needed, the following calculator (formula) may be used to estimate the value closely.
  3. Cutting speed (SFM): the rate at the workpiece surface, irrespective of the machining operation used.
  4. Tool diameter and Cut length in this calculator in inches.
  5. Milling RPM and IPM calculations use the desired tool diameter, number of teeth, cutting speed, and cutting feed, which should be chosen based on the specific cutting conditions, including the workpiece material and tool material.
Milling Speed and Feed Calculator

Milling Speed and Feed Calculator



×
=

× 12
÷
× π
=

×
=

÷
=
Glossary

Understand Spindle Speed and Feed Rate – What is Milling Spindle Speed (Milling RPM)?

The spindle speed is the rotational frequency of the spindle of the machine, such as milling machine, lathes, drills, and routers, measured in revolutions per minute (RPM). The preferred speed is determined by working backward from the desired cutting speed (SFM or m/min), which may be defined as the rate at the workpiece surface, and incorporating the diameter of cutter or workpiece. CNC milling is a process that employs computerized controls to remove material and obtain desired parts by feeding the blank into a rotating cutter with sharp teeth. In the milling operation, the tool diameter is used. In addition, RPM is the premise of IPM calculation.

Understand Spindle Speed and Feed Rate – What is Milling Feed Rate (Milling IPM)?

Feed rate is the velocity at which the cutter is fed, or the rate advanced against the workpiece, often expressed in units of distance per time for milling, that typically is inches per minute (IPM) or millimeters per minute (MPM). Milling feed rate is determined by the type of cutting tools, surface finish desired for milling parts, power available at the spindle, the rigidity of the machine and tool setup, characteristics of the material to be cut, workpiece strength, cut width, etc. To work out the feed rate, the cutting feed is required, which is the product of feed per tooth (IPT) and the number of teeth.

The Importance of Milling Speed and Feed Calculations

The spindle speed is derived from cutting feeds and speeds, it is one of the ideal cutting conditions for a tool, if the condition is not ideal, the adjustment of spindle speed is necessary, usually reduce in RPM or modify it to a correct value. Some materials can be cut at a wide range of spindle speeds, while cutting speed is critical to some materials like stainless steel, it’s easy to harden under cold working, then resist the tool’s cutting action. When determining which feed rate to use, the calculation for milling is a little more complicated, because the operation on milling machine involves multi-tipped/multi-fluted cutting tools, then the desired milling feed rate becomes dependent on the number of teeth on the cutter, and the desired amount of material per tooth to cut. Insufficient feed rate or incorrect spindle speed will cause improper cutting conditions, therefore it’s important to figure out the CNC milling speed and feed with our Milling spindle speed and feed rate calculator and control it carefully to avoid overheating of the cutter and workpiece.

Learn about our CNC milling services or require custom milling parts quotation, please feel free to contact us through the email [email protected].

Milling Speed and Feed Calculator